Achja, noch etwas:

wenn ich den mhz und cardmhz wert unterschiedlich einstelle dann kommt folgende meldung:

2011/03/23 10:55:48 4000 s creating thread for device /dev/tts/1
2011/03/23 10:55:48 10005 r reader thread started (thread= 10005, label=multicam, device=/dev/tts/1, detect=cd, mhz=357, cardmhz=600)
2011/03/23 10:55:48 10005 r WARNING: your card is asking for custom_baudrate = 714, but your configuration can only deliver custom_baudrate = -21474
2011/03/23 10:55:48 10005 r You are over- or underclocking, try OSCam when running your reader at normal clockspeed as required by your card, and se
2011/03/23 10:55:48 10005 r You are probably connecting your reader via a serial port, OSCam has more flexibility switching to custom_baudrates when
2011/03/23 10:55:48 4000 s loadbalancer: can't read from file /tmp/.oscam/stat
2011/03/23 10:55:48 4000 s waiting for local card init
2011/03/23 10:55:49 10005 r WARNING: your card is asking for custom_baudrate = 5712, but your configuration can only deliver custom_baudrate = -2147
2011/03/23 10:55:49 10005 r You are over- or underclocking, try OSCam when running your reader at normal clockspeed as required by your card, and se
2011/03/23 10:55:49 10005 r You are probably connecting your reader via a serial port, OSCam has more flexibility switching to custom_baudrates when
2011/03/23 10:55:50 10005 r multicam card detected


Sollten die Baudraten nicht jedesmal identisch sein? ...Oder ist das dann normal... Danke nochmals :-)