ok,hier mal die antworten

Bus 001 Device 004: ID 0403:6001 Bus 001 Device 003: ID 090c:1000 Bus 001 Device 002: ID 05e3:0608 Bus 001 Device 001: ID 1d6b:0002





Linux version 2.6.22.19 (root@tomato) (gcc version 4.2.4) #2 Sat Sep 4 02:34:21 EDT 2010 CPU revision is: 00019740 Found a 8MB ST compatible serial flash Determined physical RAM map: memory: 04000000 @ 00000000 (usable) On node 0 totalpages: 16384 Normal zone: 128 pages used for memmap Normal zone: 0 pages reserved Normal zone: 16256 pages, LIFO batch:3 Built 1 zonelists. Total pages: 16256 Kernel command line: root=/dev/mtdblock2 noinitrd console=ttyS0,115200 Primary instruction cache 32kB, physically tagged, 4-way, linesize 32 bytes. Primary data cache 32kB, 4-way, linesize 32 bytes. Synthesized TLB refill handler (20 instructions). Synthesized TLB load handler fastpath (32 instructions). Synthesized TLB store handler fastpath (32 instructions). Synthesized TLB modify handler fastpath (31 instructions). PID hash table entries: 256 (order: 8, 1024 bytes) CPU: BCM4716 rev 1 pkg 10 at 453 MHz Using 226.500 MHz high precision timer. console [ttyS0] enabled Dentry cache hash table entries: 8192 (order: 3, 32768 bytes) Inode-cache hash table entries: 4096 (order: 2, 16384 bytes) Memory: 61860k/65536k available (2290k kernel code, 3620k reserved, 471k data, 112k init, 0k highmem) SLUB: Genslabs=6, HWalign=32, Order=0-1, MinObjects=4, CPUs=1, Nodes=1 Calibrating delay loop... 225.28 BogoMIPS (lpj=112640) Mount-cache hash table entries: 512 NET: Registered protocol family 16 PCI: Using membase 8000000 PCI: Disabled PCI: Fixing up bus 0 PCI: Fixing up bus 1 Time: MIPS clocksource has been installed. NET: Registered protocol family 2 IP route cache hash table entries: 1024 (order: 0, 4096 bytes) TCP established hash table entries: 2048 (order: 2, 16384 bytes) TCP bind hash table entries: 2048 (order: 1, 8192 bytes) TCP: Hash tables configured (established 2048 bind 2048) TCP reno registered squashfs: version 3.0 (2006/03/15) Phillip Lougher io scheduler noop registered (default) HDLC line discipline: version $Revision: 4.8 $, maxframe=4096 N_HDLC line discipline registered. Serial: 8250/16550 driver $Revision: 1.90 $ 4 ports, IRQ sharing disabled serial8250: ttyS0 at MMIO 0x0 (irq = 8) is a 16550A PPP generic driver version 2.4.2 NET: Registered protocol family 24 PPPoL2TP kernel driver, V0.17 PPTP driver version 0.8.5-rc1 pflash: found no supported devices Creating 6 MTD partitions on "sflash": 0x00000000-0x00040000 : "pmon" 0x00040000-0x007a0000 : "linux" 0x0012d000-0x006b0000 : "rootfs" 0x006b0000-0x007a0000 : "jffs2" 0x007f0000-0x00800000 : "nvram" 0x007a0000-0x007f0000 : "board_data" u32 classifier OLD policer on Netfilter messages via NETLINK v0.30. nf_conntrack version 0.5.0 (512 buckets, 4096 max) GRE over IPv4 demultiplexor driver ip_tables: (C) 2000-2006 Netfilter Core Team net/ipv4/netfilter/tomato_ct.c [Sep 4 2010 02:32:44] NET: Registered protocol family 1 NET: Registered protocol family 10 ip6_tables: (C) 2000-2006 Netfilter Core Team NET: Registered protocol family 17 802.1Q VLAN Support v1.8 Ben Greear <greearb@candelatech.com> All bugs added by David S. Miller <davem@redhat.com> VFS: Mounted root (squashfs filesystem) readonly. Freeing unused kernel memory: 112k freed Warning: unable to open an initial console. et: module license 'unspecified' taints kernel. PCI: Setting latency timer of device 0000:00:02.0 to 64 eth0: Broadcom BCM47XX 10/100/1000 Mbps Ethernet Controller 5.10.56.46 PCI: Setting latency timer of device 0000:00:01.0 to 64 eth1: Broadcom BCM4329 802.11 Wireless Controller 5.10.56.46 Algorithmics/MIPS FPU Emulator v1.5 usbcore: registered new interface driver usbfs usbcore: registered new interface driver hub usbcore: registered new device driver usb SCSI subsystem initialized Initializing USB Mass Storage driver... usbcore: registered new interface driver usb-storage USB Mass Storage support registered. ehci_hcd: USB 2.0 'Enhanced' Host Controller (EHCI) Driver PCI: Setting latency timer of device 0000:00:04.1 to 64 ehci_hcd 0000:00:04.1: EHCI Host Controller ehci_hcd 0000:00:04.1: new USB bus registered, assigned bus number 1 ehci_hcd 0000:00:04.1: irq 5, io mem 0x18004000 ehci_hcd 0000:00:04.1: USB 0.0 started, EHCI 1.00 usb usb1: configuration #1 chosen from 1 choice hub 1-0:1.0: USB hub found hub 1-0:1.0: 2 ports detected usbcore: registered new interface driver usblp usblp: USB Printer Device Class driver vlan1: add 3300:00:00:01 mcast address to master interface vlan1: add 01:00:5e:00:00:01 mcast address to master interface usb 1-1: new high speed USB device using ehci_hcd and address 2 vlan1: dev_set_promiscuity(master, 1) device eth0 entered promiscuous mode device vlan1 entered promiscuous mode usb 1-1: configuration #1 chosen from 1 choice hub 1-1:1.0: USB hub found hub 1-1:1.0: 4 ports detected device eth1 entered promiscuous mode br0: port 2(eth1) entering learning state br0: port 1(vlan1) entering learning state br0: topology change detected, propagating br0: port 2(eth1) entering forwarding state br0: topology change detected, propagating br0: port 1(vlan1) entering forwarding state vlan2: Setting MAC address to c0 3f 0e 92 87 9f. vlan2: add 3300:00:00:01 mcast address to master interface vlan2: add 01:00:5e:00:00:01 mcast address to master interface usb 1-1.1: new high speed USB device using ehci_hcd and address 3 usb 1-1.1: configuration #1 chosen from 1 choice scsi0 : SCSI emulation for USB Mass Storage devices usb 1-1.2: new full speed USB device using ehci_hcd and address 4 usb 1-1.2: configuration #1 chosen from 1 choice scsi 0:0:0:0: Direct-Access INTENSO USB 1100 PQ: 0 ANSI: 0 CCS sd 0:0:0:0: [sda] 7831552 512-byte hardware sectors (4010 MB) sd 0:0:0:0: [sda] Write Protect is off sd 0:0:0:0: [sda] Mode Sense: 43 00 00 00 sd 0:0:0:0: [sda] Assuming drive cache: write through sd 0:0:0:0: [sda] Assuming drive cache: write through sda: sda1 sda2 sd 0:0:0:0: [sda] Attached SCSI removable disk EXT2-fs warning: mounting unchecked fs, running e2fsck is recommended