setup smargo on debian pc 5.0

[shane210585]

hallo i am installed debian server 5.0 on my pc.Everything had been done it as it showen in tutorial but my problem is my smargo donot show my card it
s++ ger##ny .i am trying it from last 1 week but till yet not success

[ 105.100007] usb 1-2: new full speed USB device using ohci_hcd and address 2
[ 105.312001] usb 1-2: configuration #1 chosen from 1 choice
[ 105.322035] usb 1-2: New USB device found, idVendor=0403, idProduct=6001
[ 105.322041] usb 1-2: New USB device strings: Mfr=0, Product=0, SerialNumber=0
[ 105.388002] usbcore: registered new interface driver usbserial
[ 105.388002] usbserial: USB Serial support registered for generic
[ 105.388002] usbcore: registered new interface driver usbserial_generic
[ 105.388002] usbserial: USB Serial Driver core
[ 105.432528] usbserial: USB Serial support registered for FTDI USB Serial Device
[ 105.432551] ftdi_sio 1-2:1.0: FTDI USB Serial Device converter detected
[ 105.432575] ftdi_sio: Detected FT232BM
[ 105.432608] usb 1-2: FTDI USB Serial Device converter now attached to ttyUSB0
[ 105.432625] usbcore: registered new interface driver ftdi_sio
[ 105.432628] ftdi_sio: v1.4.3:USB FTDI Serial Converters Driver


this what my pc show me by attaching smargo

my cfg setting

SERIAL READER : /dev/ttyUSB0 smartreader+

pls help me to resovle this problem.

[hansie45]

Try it with Protocol Mouse (NOT Smartreader, not internal)and dont try newer FTDI Driver (wont work).
On Ubuntu 9.04 al is running fine, on 9.10 nothing ist running, and one Difference is a new FTDI.

Also play with no mhz and no cardmhz and fixed Baudrate on Smargo, but only on Protocol Mouse.
Remember, if you one Time use Smartreader Protocol, you must remove your Smargo for to work again on Mouse Protocol! If you dont, no Card will be recogniced

[shane210585]

hi sir

as i told that i am using debian 5.0 server and what is Try it with Protocol Mouse how to do that i have no idee.pls help me further

[Fubbel]

hi,

what cardserver do u use? u set mouse in the reader section for the card.
mpcs.reader for example.

running debian 5.0.3 too and smargo in usb. runs fine for me. i use the x64 version if debian. but shouldn't make too much difference.

cu

[shane210585]

Hi i am zwing debian 5.0 Server edition 32 Bit and cccam on it
u had Said to setup Mouse , u meant in cfg or somewhere Else
bro it is possible to Backup ur Server then can i install it on
my pc my pc is also 64 b actually but i had trief 32b

[Fubbel]

won't make too much sense backing mine up.

i am using mpcs as cardserver by the way. not cccam server.

this option must be set in the cfg file yes. but as i never used cccam server i cannot tell u how exactly to change it for cccam server.

there is also a good howto for mpcs in the forum.

cu